Introduction to Manufacturing Process of Steel Structure Processing Plant

Rust removal and rust prevention process.Welds,bolts,or rivets are usually used to connect various components or components.Due to its light weight and easy construction,it is widely used in large factories,venues,super high-rise buildings and other fields.Steel structures are prone to corrosion,and generally steel structures require

Rust removal,galvanizing or coating,and regular maintenance is required.The steel structure processing factory will explain the production process of this product.

1.The design drawings provided by the architectural design institute cannot be directly used for processing and manufacturing steel structures.Instead,it is necessary to consider the processing technology,such as tolerance fit,processing allowance,welding control,and other factors,and draw processing and manufacturing drawings on the basis of the original design drawings.Processing

Drawing is the process of communicating the intentions of designers and construction personnel.It serves as a key document for production,as well as various aspects such as actual dimensions,marking,cutting,groove processing,punching,bending,assembly,welding,painting,product inspection,stacking,and sending

The instruction book for homework also serves as a checklist for high-level management.

2.Analysis of construction conditions before processing and production

When drawing processing and manufacturing drawings or reviewing design drawings,it is necessary to analyze and study the construction conditions or difficulty level while reviewing.It is necessary to carefully analyze the parts with high welding difficulty,whether to use high-strength bolts and fastening tools,and whether to maintain the welding angle of the welding rod in narrow areas

.

3.Steel tape measures are mainly used in steel structure processing plant engineering,using any one of the primary products of tape measures,broadband steel tape measures,and convex steel tape measures.Make the factory tape measure and the on-site tape measure belong to the same category of products,that is,use the same tape measure between different professions

”.If there are difficulties,the mutual difference between 10m should be controlled within 0.5mm.

4.On duty operators should receive training and assessment,and special types of work should undergo qualification confirmation.Technical disclosure work for each process should be fully carried out.