Steel structure of equipment plant

The steel structure of the equipment factory is lightweight, easy to disassemble and install, and easy to transport. The steel structure of the equipment factory has the characteristic of easy production and installation, but it is prone to corrosion and rust caused by rainwater erosion, leading to water leakage. So daily maintenance work should be done well.

(1) Remove the silicone adhesive seal from the original protruding part, maintain a positive atmosphere, and ensure that the construction surface is dry and clean;

(2) First, apply the primer with adhesive paint, then use alkali resistant polyester cloth to coat the surface, and then apply the adhesive paint;

(3) Dry for 2-3 hours before applying ice paint once, and apply twice after 3 hours;

(4) If the gap at the overlap is greater than 5mm-30mm, if it is necessary to strengthen the adhesion, please add another layer of alkali resistant polyester cloth and apply a third layer of adhesive paint in 3 hours;

(5) Foam plug can be used to fill two layers of adhesive paint at the overlapping trough of ridge tile and roof tile edge plate to prevent water seepage and flashing;

(6) The rivet and self tapping nail holes can be directly covered with a brush of adhesive paint four times, with a thickness of about 1.5mm and a diameter of about 50mm. The next layer applied should not stick to the hands.

The steel structure of the equipment plant is relatively stable in structure, with beautiful craftsmanship, which can utilize land area and facilitate vehicle parking. In addition, the steel structure of the equipment plant adopts active connections. Meet people's requirements.

Nowadays, steel structure engineering is widely used in the construction of various buildings, and the construction of different buildings naturally has different requirements. For example, the steel structure of equipment factories cannot be built casually, and there are many key points that need to be noted.

1、 As a workshop, the load-bearing capacity needs to be very high. So when it comes to selecting panel materials, determining construction loads, maintenance loads, and so on, none of these can be ignored.

2、 The construction area of the steel structure of the equipment factory is generally relatively large, and the lighting inside the workshop can be improved through skylights during the day. So in metal roofs, well-designed daylighting panels or glass are necessary to greatly assist in the daytime lighting of the workshop and save energy on the steel structure of the equipment plant.

3、 Since it is a workshop, there will be a lot of raw materials piled up, so in order to protect the raw materials and finished products, the treatment of the steel structure in the equipment factory cannot be ignored. Sufficient insulation cotton can be filled in the metal layer, and a film can be laid on the bottom plate.

4、 Lightning protection. Summer is dry, the fire is flammable, and summer thunder can easily strike buildings, which can easily cause fires. So this is important. The materials used for the construction of the steel structure of the equipment plant should not be flammable, so that flames will not penetrate the metal roof panels.

5、 Anti leakage. It has a similar effect in preventing rainwater from leaking in and damaging workshop machines and items. Therefore, anti leakage treatment should be done in the overlapping joints of steel structures, using sealant or welding treatment can effectively prevent such situations from occurring.